Basic Info
- What is it: a textile pocket, more explanation shared below
- Material: soft/bendable | standard tolerance
- Dimensions: ~400mm x ~200mm x ~100mm | standard tolerance
- Holes: no holes
Pocket explanation
These pockets are created to attach something and to be attached:
Board support
All pockets have two departments inside. This allows you to insert a suitable board (e.g. 080.1, 080.2, 080.3 for the large pocket or 122.1 for the small one) in to give it structural strength.
Get the part
- Buy: Available as local make
- Make: The designer Arlie Lambright shared has shared this pattern:
Meta
- Introduced by: Arlie Lambright via X-mat
- Original Post, Original Post Backup (Safari webarchive)
- Open: IPP 1.0
- Disclaimer
Download Portal
Most parts have open design and manufacturing files you can download and work with.
0P3N Portal
More Parts
101.2 – Bead ⌀ ~16mm, ⌀ 6mm hole
143.1 – Wire mesh, bendable, 330x330mm
107.1 – Beam 450x30x30mm
134.1 – 4 corner bracket Round
140.1 – Board 450x330mm, ⌀10mm holes
034.1 – Spacer ~40mm high
021.3 – Disk ⌀ ~75mm, 6mm holes
107.1 – Beam 450x30x30mm
121.1 – board ~420x360mm
086.1 – M4 countersunk bolt 20mm
125.3 – Foam small 400x200x50mm
079.1 – Beam 270mm
Pl⚲y (ノ✿◠‿◠)ノ .-‘ °
Do you have any new ideas on how to re-use these parts? Share it.