Basic Info
- What is it: a board
- Material: strong | standard tolerance
- Dimensions: ~360mm x ~150mm x ~16mm | standard tolerance
- Holes: 2 holes, Ikego Grid / 3erlin Grid, diameter 6mm, location see drawing below
Get the part
- Buy: Available as local make
- Make: No further instructions
Meta
- Introduced by: Lars Zimmermann via WORMS, original post | original post backup.pdf
- Open: Shared under IPP 1.0
- Disclaimer: This part is just a concept and not fully tested. You should not assume that it works as indicated and I am not saying that it does. I disclaim any responsibility or liability for any damage caused during the construction and use of products based in whole or in part on the concept shown here. All information is provided for your use at your own risk.
Got an idea for this part? ↑ Share it. Become an Ikego designer.
Plates, Boards, Disks • Rods & Rails • Beams • Tubes • Bendables • Electricity • Fasteners • Other
