‘Tetri Wall Organizer‘ – info soon
by Béla Raketa
Status: Prototype
Design info
1 prototypes, 1 make, 0 products info
On parts & builds
- …
Meta info
- Please visit the original post by the designer to find even more information. Initial post backup.pdf
- All makes shown in this post were created by Mifactori.
- Disclaimer
Universal parts
142.2 – Board 330x330mm, ⌀10mm holes
140.1 – Board 450x330mm, ⌀10mm holes
102.2 – Board ~300x300x16mm – “Tetri Board”
101.3 – Flexible bead ⌀ ~16mm, ⌀ 2mm hole
101.2 – Bead ⌀ ~16mm, ⌀ 6mm hole
101.1 – Bead ⌀ ~16mm, ⌀ 4mm hole
095.1 – 30mm rod M6 insert, ⌀ ~30mm, “elephant rod”
089.1 – M6 nut
088.1 – M6 wing nut
086.2 – M4 bolt 50mm
086.1 – M4 countersunk bolt 20mm
077.1 – M6 eye bolt ~40mm
072.1 – Spacer ~15mm high
069.1 – M4 washer 15mm
068.2 – M4 ringbolt 40mm
062.1 – Clockwork
055.1 – Rubber band 300mm
043.1 – Plastic nut & bolt ~30mm ⌀ 10mm
039.1 – Carabiner 40mm
035.1 – Reusable cable tie 150mm
030.2 – M6 bolt 15mm
027.1 – Rubber band ring ~150mm
025.1 – M4 hook ~40mm
023.1 – Loop clip
020.1 – M4 bolt 4-9mm
019.1 – M4 nut
018.3 – Bungee cord, ⌀ 3mm, ~1000mm
018.1 – String 2000-2500mm
014.1 – Hook small
013.1 – E14 bulb holder
010.1 – Cable with plug and switch
008.1 – Plastic threaded rod & bolts ⌀ 10mm
006.1 – Wire 500 mm long, 2mm thick
004.1 – Washer disk ⌀ 40mm
Tetri Wall Organizer
NOTE: This set has more than one model. Not all parts in the list are required to assemble each version.
NOTE: There is more than one way to assemble this model. Some parts are interchangeable. Not every part in the list ist required for each way.
